SEN0098

Analogue 50A current sensor (AC/DC) breakout board for the fully integrated Hall effect based linear ACS758 current sensor. The sensor gives precise current measurement for both AC and DC signals. The thickness of the copper conductor allows survival of the device at high overcurrent conditions. This current sensor enables you to monitor currents in your project every second for energy saving or circuit protecting purposes.

• Arduino interface compatible
• 120kHz typical bandwidth
• Output voltage proportional to AC or DC currents
• Factory-trimmed for accuracy
• Extremely stable output offset voltage
• Nearly zero magnetic hysteresis
• Total output error improvement through gain and offset trim over temperature
• Monolithic hall IC for high reliability
• Ultra-low power loss: 100μΩ internal conductor resistance
• Operating Voltage: 3.3-5V (analogue)
• Peak Measuring Voltage: 3000V AC, 500V DC
• Current Measuring Range: -50 to +50A
• Sensitivity: 40mV/A
• Operating Temperature: -40 to 150°C
• Board size: 34x34mm

Aplikácie

Embedded Design & Development, Electronics Design, IoT (Internet of Things)

Obsah

Sensor board, Analogue sensor cable (FIT0031).